Faq
- How does ISOLINE® LOW LINE function?
- What are the main types of roof structures that ISOLINE® LOW LINE can be installed on?
- What is the required penetration depth for fixings?
- Where exactly should the fixings penetrate the ISOLINE® sheets?
- Can I use a breathable membrane in conjunction with ISOLINE and a full deck?
- Will my tiles leak if installed at a low pitch?
- Do I need to install counter-battens on a full deck roof to ensure proper ventilation beneath the ISOLINE system?
- Will the ISOLINE sheet leak where fixings penetrate it?
- What is the minimum roof pitch ISOLINE® LOW LINE is accredited for?
- Do I need to keep to the original tiling gauge when installing tiles on top of an ISOLINE roof?
- Can I use PV / Solar Panels in an ISOLINE roof?
- Heritage Specific: Is ISOLINE LOW LINE safe for Bats?
- What is the minimum and maximum pitch for ISOLINE?
- Can I use ISOLINE on a vertical wall or as cladding?
- Do I need Fire Barriers with ISOLINE?
- Is ISOLINE breathable?
- How do the ISOLINE® LOW LINE sheets overlap?
- How much weight can ISOLINE LOW LINE take on top?
- What is the maximum tiling gauge that can be used?
- Can I install a Roof Window with ISOLINE?
- Are there specific ventilation requirements for this system?
- How long can ISOLINE LOW LINE be left exposed without a tile covering?
- How should contractors walk on the roof during installation?
- Do you need to use a Breathable Membrane in conjunction with ISOLINE LOW LINE?
- What precautions should be taken when installing roof tiles below the manufacturer's minimum recommended pitch?
- Can ISOLINE® LOW LINE sheets be used as a structural component when fixing solar panels?
- Where does the flashing sit? above or below the isoline sheet?
How do the ISOLINE® LOW LINE sheets overlap?
- Horizontal Overlap (End Lap): Overlap the sheets by aligning the two horizontally embossed interlocking guidelines on the top and bottom sheets, which provides approximately 220mm of end lap coverage.
- Vertical Overlap (Side Lap): Use two corrugations, which is approximately 100mm.
- Staggering: Similar to tiling, sheets must be staggered as you work upwards. This is done by starting the second row with a 'half-sheet'.
Do you need more details ?
Did you find what you were looking for?